Mitsubishi Electric Air Conditioner Making Noise, A Sound Guide

Mitsubishi Electric systems have a reputation for running quietly, so a Mitsubishi Electric air conditioner making noise tends to get noticed fast.

Some sounds are a normal part of how heat pumps work. Others point to loose parts, debris or wear. This guide sorts the harmless from the worrying so you know what to do next.

Normal sounds that are nothing to worry about

Before looking for faults, it helps to know the everyday sounds of a healthy heat pump. Knowing these saves worry and avoids an unnecessary call out.

Soft clicks and ticks

Plastic panels expand as they warm and contract as they cool, and the effect is strongest when the temperature changes quickly. That movement produces gentle ticking, especially just after switching on or off. Relays on the circuit boards also click as they switch.

Whooshing or gurgling

Refrigerant flowing through pipes can make a soft whoosh, and a gurgle can occur when the system starts, stops or changes mode. These sounds are normal in small doses.

A hiss during defrost

In heating mode, the outdoor unit runs defrost cycles. During defrost, you may hear a hiss or a sudden whoosh as the system reverses, followed by steam from the outdoor coil.

The hum of the compressor

The outdoor unit hums while the compressor runs. Inverter compressors change speed, so the pitch rises and falls as the load changes.

If the sound you hear fits one of these and happens at the expected times, your system is probably fine.

Rattling and vibrating

Rattles usually mean something is loose or touching something it should not. Fortunately, they are often the easiest noises to fix.

  • A loose front panel or filter on the indoor unit.
  • Screws that have worked loose on the outdoor casing.
  • Pipes touching a wall, gutter or fence and vibrating.
  • Mounting brackets that have loosened over time.
  • Debris such as twigs or stones inside the outdoor unit.

Check that the front panel and filters are properly seated. With the isolator off, look around the outdoor unit for anything touching it or lodged inside the grille. Never reach inside the fan.

Buzzing

A buzz can be harmless or serious, depending on where it comes from and how it changes over time.

From the indoor unit

A faint buzz may come from the fan motor or the electronics. If it grows louder or comes with a burning smell, switch off at the switchboard straight away.

From the outdoor unit

A buzz with no fan movement can mean the fan motor is trying to start but cannot. A buzz from the electrical area may point to a failing contactor or a loose connection. Either case needs a technician.

Burning smell or smoke

If any noise comes with a burning smell, smoke or scorch marks, switch the system off at the switchboard, keep away and call a licensed technician immediately.

Squealing and screeching

High pitched squeals often come from worn fan motor bearings. The sound may be loudest on start up, then fade as the motor warms. Left alone, worn bearings can seize, which stops the fan and may trigger a code such as U8. Replacing a noisy motor before it seizes is usually far less disruptive. A squeal from the indoor unit may also point to a dry or worn indoor fan bearing.

Grinding

Grinding is never a good sign, and it should not be ignored. It can mean a fan blade rubbing against its housing, debris caught in the fan or, more seriously, internal compressor wear. Switch the system off and book a technician. Running a grinding fan or compressor can turn a moderate repair into a major one.

Banging or knocking

A loud bang or knock at start up can come from a compressor struggling to start, liquid refrigerant in the compressor or a loose mounting. Repeated knocking during running can mean something is loose inside the outdoor unit. These sounds deserve a professional check, ideally before the system is used much further.

Hissing that will not stop

A brief hiss during start up, shut down or defrost is normal. A continuous hiss, especially near pipe joints, may indicate a refrigerant leak. If you also notice weaker cooling or frost on the outdoor pipes, book a technician. Our gas and regas page explains leak repairs.

Water gurgling and dripping sounds

A gurgle from the drain can happen when air and water mix in the drain hose. It is often harmless, particularly when the system first starts or on very humid days when lots of water flows. However, constant gurgling with a musty smell may mean the drain is partly blocked. A dripping sound inside the unit can point to an overflowing tray. Our guide on a Mitsubishi Electric leaking water covers drain problems.

Noises from the indoor fan

The indoor unit uses a long cylindrical fan, sometimes called a barrel or cross flow fan. Over time, dust and grime build up on its blades, which can unbalance it. An unbalanced fan wobbles, hums or rumbles. A professional clean of the fan barrel usually restores quiet running and also improves airflow. Because the barrel sits deep inside the unit, cleaning it properly needs the right tools and care, so it is best left to a technician rather than attempted with a brush from the outside.

Noises from the outdoor fan

Outdoor fans face leaves, twigs, insects and weather. A blade that strikes debris makes a ticking or slapping sound. A cracked blade can cause vibration. Worn bearings make the squeals described above. Our outdoor unit check explains how to look for debris safely.

Noise that changes with the weather

Some sounds appear only in certain conditions, and that is a useful clue in itself. Defrost noises happen in cold, damp weather. Strong winds can make outdoor fan blades flutter. Very hot days push the compressor harder, so its hum may become louder. Noting the conditions helps the technician decide whether a sound is normal.

Sounds that come and go at night

At night, background noise drops, so you notice sounds you would miss during the day. Inverter systems may also cycle gently near the set temperature, producing soft whooshes and clicks. If a sound seems louder at night but has not changed, it may simply be more noticeable. If it is new or growing, it is worth a check.

Noise from the pipes inside the wall

The copper pipes linking the indoor and outdoor units pass through the wall behind the indoor unit. If they touch a stud, a bracket or each other, refrigerant flow and compressor vibration can travel along them and create a hum or rattle that seems to come from the wall itself. Pipe clips that have loosened over time make this worse. A technician can often reduce the noise by adding padding or re securing the pipes where they are reachable.

Noise after a service or repair

Occasionally, a new noise appears soon after someone has worked on the system. A front panel may not be fully clipped in, a screw on the outdoor casing may be missing, or a pipe may have been nudged against a wall. If the noise started straight after a visit, contact whoever did the work first. It is usually a quick fix.

Is a louder outdoor unit always a fault?

Not always. On very hot days, the compressor and outdoor fan run faster to keep up, so the unit is naturally louder. In addition, a unit tucked into a narrow passage or beside a hard fence can sound louder because sound bounces back. However, if the unit has become noticeably louder than it used to be in similar weather, something may have changed, such as wear in the fan or compressor mounts.

Neighbours and noise

In tight Sydney streets and apartment blocks, outdoor units often sit close to neighbouring windows. A unit that rattles or hums loudly at night can cause friction. Fixing loose panels, clearing debris and replacing worn fan bearings usually brings the sound back down. If placement is the issue, a technician can talk about options such as anti vibration mounts or relocating the unit during a future upgrade. Strata rules may also apply in apartments.

Simple steps you can take

  1. Check that the indoor front panel and filters sit properly.
  2. Clean the filters if they look dusty.
  3. Switch off the isolator and look for debris around the outdoor unit.
  4. Make sure nothing touches the outdoor unit or the pipes.
  5. Record a short video with sound, so the technician can hear it.

Our guide to cleaning Mitsubishi Electric filters explains how to refit filters correctly.

Describing a noise clearly

Noises are hard to describe over the phone, so a little structure helps. Think about where the sound comes from, the indoor or outdoor unit. Then note when it happens, such as at start up, while running, at shut down or during defrost. Finally, describe its character, for example a click, rattle, buzz, squeal, grind, bang or hiss. A short video with sound captures all of this in one go.

Technicians can often narrow down a noise from a good description alone. That means they arrive with a clearer idea of which parts to check and which spares might be needed.

Can noise mean the system is about to fail?

Sometimes. Noises often give early warning of wear. A bearing that squeals today may seize next month. Likewise, a loose terminal that buzzes may later burn. A compressor that knocks at start up may eventually refuse to start. Acting while the system still runs usually means a smaller repair, less inconvenience and no emergency during a heatwave.

Do older units get noisier?

Generally, yes. Over many years, fan bearings wear, rubber mounts harden and plastic panels lose a little of their fit. Dust also builds up on fans, which can unbalance them. None of this means an old unit must be replaced, but it does mean servicing becomes more valuable as the system ages.

When to call a technician

Book a visit for any of these, even if the system still seems to cool or heat normally.

  • Grinding, screeching or loud banging.
  • Buzzing with no fan movement.
  • Any noise with a burning smell or smoke.
  • Continuous hissing with weak cooling.
  • A noise that is new and getting louder.

Our repair page explains how a repair visit works.

What the technician checks

The technician listens to the noise, then isolates the power and inspects the relevant parts. They check fan bearings, blade balance, mountings, panels and pipe clips. On the outdoor unit, they look for debris and loose screws. If a refrigerant or compressor noise is suspected, they measure pressures and current.

Keeping your system quiet

  • Clean filters regularly so the fan does not strain.
  • Keep the outdoor unit clear of debris.
  • Book servicing so fan barrels and coils get cleaned.
  • Ask for loose screws and pipe clips to be tightened during a service.
  • Act on new noises early.

Our service page explains what a service covers.

Final thoughts on a Mitsubishi Electric air conditioner making noise

A Mitsubishi Electric air conditioner making noise is not always a problem. Clicks, gentle whooshes and defrost hisses are normal. Rattles, buzzes, squeals, grinding and continuous hissing are not, and they usually point to loose parts, debris, worn bearings or leaks.

If a noise worries you, book a Mitsubishi Electric technician to track it down before it becomes a breakdown.

Frequently asked questions

Is it normal for my Mitsubishi Electric to click?

Yes. Gentle clicks and ticks come from plastic expanding and contracting and from relays switching.

Why does my outdoor unit hiss in winter?

During defrost, the system reverses and may hiss or whoosh. Steam from the outdoor coil is also normal.

What does a squealing noise mean?

Squealing often means worn fan motor bearings, which should be checked before the motor fails.

Why is my indoor unit rumbling?

A dirty, unbalanced fan barrel can rumble or hum. A professional clean usually solves it.

Should I worry about a grinding noise?

Yes. Switch off and book a technician, because grinding can mean a rubbing fan or compressor wear.

What if the noise comes with a burning smell?

Switch off at the switchboard immediately and call a licensed technician.

{“@context”:”https://schema.org”,”@type”:”HVACBusiness”,”@id”:”https://mitsubishi.sydneyaircare.com.au/#business”,”name”:”Sydney Air Care, Mitsubishi Electric Service”,”url”:”https://mitsubishi.sydneyaircare.com.au/”,”description”:”Mitsubishi Electric air conditioner repair, service and troubleshooting across Sydney. Independent service provider, not affiliated with Mitsubishi Electric.”,”areaServed”:[{“@type”:”City”,”name”:”Sydney”},{“@type”:”State”,”name”:”New South Wales”}],”parentOrganization”:{“@type”:”Organization”,”name”:”Sydney Air Care”,”url”:”https://sydneyaircare.com.au/”},”telephone”:”+61 2 9071 1142″} {“@context”:”https://schema.org”,”@type”:”FAQPage”,”mainEntity”:[{“@type”:”Question”,”name”:”Is it normal for my Mitsubishi Electric to click?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Yes. Gentle clicks and ticks come from plastic expanding and contracting and from relays switching.”}},{“@type”:”Question”,”name”:”Why does my outdoor unit hiss in winter?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”During defrost, the system reverses and may hiss or whoosh. Steam from the outdoor coil is also normal.”}},{“@type”:”Question”,”name”:”What does a squealing noise mean?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Squealing often means worn fan motor bearings, which should be checked before the motor fails.”}},{“@type”:”Question”,”name”:”Why is my indoor unit rumbling?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”A dirty, unbalanced fan barrel can rumble or hum. A professional clean usually solves it.”}},{“@type”:”Question”,”name”:”Should I worry about a grinding noise?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Yes. Switch off and book a technician, because grinding can mean a rubbing fan or compressor wear.”}},{“@type”:”Question”,”name”:”What if the noise comes with a burning smell?”,”acceptedAnswer”:{“@type”:”Answer”,”text”:”Switch off at the switchboard immediately and call a licensed technician.”}}]}
Call 02 9071 1142